Posted by Brent Zappe on December 10, 2022 at 06:00:45 from (104.192.91.205):
I have a 2010 ford F-250 super duty diesel truck with a 6.4 diesel engine. that needs the Dual Alternators to be replaced. I have read my Service book they tell me to take the top of the truck apart to get to them to replace them. Now when I get on you tubes to see what everybody is doing. they are taking the inner fender well out to get to the Alternator. What is interesting is that nobody shows a way to change the Daul Alternators on this truck. So, my question is what the best way is to do this. Should I take apart the stuff on the top of this engine compartment to get to both of them OR shall I try to just take the inner fender out and hope I can get to the upper one as the bottom one. that I need to ask has anybody out here have a truck like mine. With Daul Alternators on it? Yes. I have to say never have I owned a truck with Daul Alternators on it. I am looking for the best way to get into them and replace them. any suggestions you have might be a big help thanks.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
