Posted by gbs on January 13, 2023 at 20:22:27 from (71.217.169.27):
even though several electricians have explained to me i can't seem to understand the purpose of the green bonding screw being used or not in a single phase 220 volt electrical panel box when followed by a sub panel. i know it's suppose to connect the neutral and equipment grd bars to the panel box there by creating equal potential of the metal box and the bars. what i can't grasp is the service neutral wire that comes from the transformer is bonded to the system neutral which is a grounding system that also has a ground rod at the pole, then that it is connected to the meter back thru it to the main panel neutral bar which has a driven ground rod connect to it, also the neutral bar is mounted directly to the box with screws as well as the equipment ground bar is screwed to the box if not mounted to the neutral bar itself . so what is the need of the green screw and the second extra coated ground wire between the boxes when they are already bonded as described?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
