|
Tractor Talk Discussion Board |
Re: Plowing -- how to instructions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Dave on February 12, 2002 at 11:32:15 from (24.104.94.34):
In Reply to: Plowing -- how to instructions posted by dap on February 12, 2002 at 10:52:16:
What you need is somebody in your area who knows what they are doing and is willing to show you how. There are a lot of adjustments to be made that can make the difference between a good job with a nice pulling plow and a lot of work with a messed up field.
Are you a member of any antique tractor clubs? Many of them have "plow days" where they get together and turn over dirt with their old tractors, just for fun. It's a good way to "pick the brains" of several guys and gain some knowledge. To me it's a lot more fun than tractor pulling because it's what the tractor was made for.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
