|
Tractor Talk Discussion Board |
Re: shtuck shteering wheel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg D. on April 09, 2002 at 19:04:11 from (209.240.222.130):
In Reply to: shtuck shteering wheel posted by Skiploader bob on April 08, 2002 at 19:18:04:
After soaking with your favorite penetraring oil. Find a ball bearing and a nut to fit the shaft. Weld the bearing to the nut with a Stainless or similar based rod. Thread the nut all the way onto the shaft so the ball makes contact with the shaft and while keeing a pull on the wheel, strike the ball, it should loosen up and with the nut on the shaft, you won`t go flying when it loosens up.
Don`t forget safety glasses and gloves just in case.
Follow Ups:
Home
| Forums
Today's Featured Article -
Using Your Tractor: Creating a Seed Bed - by Chris Pratt. When I bought my first old tractor, I had only one idea in mind. It wasn't the preservation of old iron since at that time, I was unaware that people even did this. It wasn't to show off my restoration skills (though I had tried my hand at a couple of old motorcycles in my teens and if I recall correctly, those old motorcycles were sold in boxes about one quarter finished). It wasn't to relive memories of Grampa, Dad or myself out on the back 40 nursing the Farmall pulling too many b
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
