Tractor Talk Discussion Board |
Re: Re: Where are your trailer lites mounted? or how are they protected?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on April 17, 2002 at 12:06:38 from (155.14.78.39):
In Reply to: Re: Where are your trailer lites mounted? or how are they protected? posted by JWC on April 17, 2002 at 10:24:32:
JWC - Thanks for the lite solution. I will look into this, should be easy enough. Wal-Mart has become my sole source of trailer lites given the volume of damage. As to the IH 37 disk. Come along is a cable type. I attach the ratchet end on the rear of the frame and spool the cable out to the center of the frame and then wrap cable around the frame and hook around itself. The ratchet is then operated to lift the entire assy. I then place a short hank of chain around frame and hold in place with a binder. This works well during transport. During actual use it is a ROYAL PITA having to get off, raise, get on, turn entire rig, get off, lower, get back on, and then run to opposite end of field. REPEAT for each pass and cross-pass. While hard work hasn't killed me yet and I enjoy working my place, here lately I really DREAD disking. Thank goodness for Daylite Savings Time!! I must say though, it is much better than my previous all day/nite efforts with my 3pth 6' set (way to lite & to narrow). I'm going to steal your turnbuckle idea - I could use 2 of them, one on my disk harrow and the other on the Oliver 4340 plow. Most fields are sandy and plowed to a depth of 8". Some of the others are deep clay with standing water after a good rain. The sand is easy to work, but is hard on equipment and leaches fert. etc. real quick which adds cost to most growing operations.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|