Tractor Talk Discussion Board |
Re: Cub Cadet PTO electric clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John in Maryland on May 10, 2002 at 11:54:54 from (66.56.220.94):
In Reply to: Cub Cadet PTO electric clutch posted by PCC-AL on May 10, 2002 at 03:27:26:
It just won't come back on at all, or did it just cut off that one time? Sounds about time for a new pto clutch, so that would be my first guess, I think it'll run about $100 or so, not too hard to change. With the key on, but the tractor off, flip the switch on, you should here it engage. If not, it's the clutch or you blew a fuse or something came unconnected. You said you checked the fuses(though try swapping it if you have an extra, have seen them before not look blown but just stop working). You said you checked the plug, so I am guessing all wires are still intact. So that would leave the clutch. I guess you've turn the switch off then back on again, and I assume you know you have to be on the seat and not in reverse(unless you unhooked that switch, which is real easy by the way, let me know if you want to know where it is and how to do it). It could also be the switch, so check that out as well. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|