Tractor Talk Discussion Board |
Re: One more pole barn concrete question..
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on October 24, 2002 at 12:53:35 from (195.93.34.10):
In Reply to: One more pole barn concrete question.. posted by Dave_D on October 24, 2002 at 09:00:50:
If the poles are steel, then there should be no problem. Steel bars have been used for concrete reinforcement since..... with no problems - unless the steel corrodes. The good thing is the linear thermal expansion coefficient of concrete is nearly the same as for steel. The more likely cause for cracking would be a large masss of concrete under severe thermal stress and cracking from a point around your poles. Dividing the slab into smaller blocks is probably a more important factor. Just my 2p worth. Regards, RAB
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|