Tractor Talk Discussion Board |
Re: My buddy got a good screwin' at the JD dealer today
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on December 08, 2002 at 14:32:33 from (209.47.89.128):
In Reply to: My buddy got a good screwin' at the JD dealer today posted by Duane(Pa) on December 07, 2002 at 17:37:09:
Once a guy fights his way through the sarcasm and chest-thumping in many of the previous posts, I think the basic fact remains is that $20 (or more) for a needle and seat is definitely high-priced no matter WHERE you buy it. It's not like they're made one at a time in some little machine shop. In our worthless Canadian dollars, that would be about $32 and you can usually buy a whole carb rebuild kit (say at NAPA, etc.) for far less than that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|