|
Tractor Talk Discussion Board |
Re: IH Date Codes on Castings - Can Anyone Splain it to Me ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on January 12, 2003 at 12:27:14 from (63.147.130.94):
In Reply to: IH Date Codes on Castings - Can Anyone Splain it to Me ? posted by Glenn Ayers on January 11, 2003 at 13:11:19:
Farmall tractors made in the 30's, 40's, and 50's had serial numbers stamped in serial number plate, frame, and also in the side of block. The serial numbers stamped in these 3 places should match and you can cross that number over to a serial number chart and determine what year your tractor is. This is the best way to determine what year it is. If the numbers don't match in the 3 places then chances are that the tractor has been peiced together over the years (2 or 3 tractors put together as 1). Now that that is cleared up, the numbers you are talking about are the numbers that are casted into major parts (such as the ones you mentioned). Farmall casted these parts with a number that could identify when the parts were indeed made. So like 5 13 E is actually month, day, and year with the year being indicated with a letter. That is the explaination of the numbers you are talking about, however these numbers might not all match up on the tractor simply because the transmission might of been made one day and the tractor assembled 2 weeks later. I am not sure what letters represent which years. I think the years are in alphabetical order (not sure when it started) but not all letters were used.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
