|
Tractor Talk Discussion Board |
Re: Hydraulic Valve Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jake on February 16, 2003 at 08:49:45 from (198.111.220.147):
In Reply to: Hydraulic Valve Question posted by Darrel on February 15, 2003 at 15:01:01:
On garden tractors & mowers the hydraulic valve are open center to prevent pressure buildup damaging the pump. Pressure in thes units is in the 700-1100# range with a flow under 5 GPM. If your cylinder has a port on each end it is a double acting and will require that type of control. If there is one hose on the cyl it is a silngle acting tupe. Surplus Center 1 800 488 3407 has several types with good prices [29-50 bucks]
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
