Tractor Talk Discussion Board |
Re: Help..Farmall 300 PTO
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jmyt_47 on May 19, 2003 at 11:00:41 from (170.92.1.104):
In Reply to: Help..Farmall 300 PTO posted by Bob Oriskany on May 19, 2003 at 07:56:36:
I just rebuilt a 300 front to back. The good news is that it sounds like a broken bearing or chipped gear. Parts are cheap, but labor isn't unless you do it yourself. Pull the rear pto unit and inspect the gears. Most likely the problem will be in the forward part of the transmission housing. Remove the inspection plates(seasonal disconnect) on the lower part of the T/A housing to get a good look. You may be able to fix the bearings without spliting the tractor in half.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|