Tractor Talk Discussion Board |
Re: Re: What size round bale can I haul?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by red-n-green on September 09, 2003 at 17:55:56 from (67.216.65.87):
In Reply to: Re: What size round bale can I haul? posted by Gary in Tx on September 09, 2003 at 07:43:56:
Just a comment on 3010 or 3020. I have a 3010D and when I roll 5X6 rolls of bermuda, these rolls will lift the front end off the ground. Thats even with a full 35 gallon fuel tank in the front of the tractor. But on the other hand I have moved alot of 4X5 and 5X5 rolls with a 430 Case which is only about 34hp. FWIW. Jay
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|