|
Tractor Talk Discussion Board |
Re: Pole barn
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve from Tn on November 30, 2003 at 05:49:22 from (208.128.241.8):
In Reply to: Pole barn posted by Slofr8 on November 29, 2003 at 19:39:54:
I am building a pole barn and learning as I go. A couple of suggestions. Treated 4X4's are about $25 each. Of course, 4X6's are a little higher. We put them in the ground with a bag of redi-mix around each pole. I believe we put a 4X6 every 12 feet and a 4X4 on each side of every door. The other thing is to make the length and width in multiples of 3. The metal sheets are 3 feet wide and it works out better this way. One more thing: keep it square. An old-timer is helping me and guiding me. He is 81 and I had to make him get off the roof and let me drive those screws in. I hope I do half as well at that age. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Old Time Threshing - by Anthony West. A lovely harvest evening late September 1947, I was a school boy, like all school boys I loved harvest time. The golden corn ripens well and early, the stoking, stacking,.... the drawing in with the tractors and trailers and a few buck rakes thrown in, and possibly a heavy horse. It would be a great day for the collies and the terrier dogs, rats and mice would be at the bottom of the stacks so the dogs, would have a busy time hunting and killing, all the corn was gathered and ricked in what we c
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
