Re: Howard Trans

Posted by jimNCal on December 28, 2003 at 01:48:22 from (66.53.200.61):

In Reply to: Howard Trans posted by Ray on December 09, 2003 at 19:52:42:

Ray,

Sorry to post weeks later. You have an Everett trencher trans unit which is self contained in it's own case right? This is completely different than the Howard "rotovator" trans. The Howard is a set of gears designed to go into the rear end cavity and attached to the back of the standard trans. The Everett is made to bolt between the rear of the trans and the front of the rear end also but it lengthens the tractor by 9 3/4". The Howard is intended for rototilling @ 3.5 to one and the Everett was intended for deep trenching @ 98:1 I have Everetts for both my Jubilee and 8N. I paid $300.00 for the Jube's unit in mint condition and $100.00 for the 8N's with a bearing that needed replacing. As you can tell from the lack of interest on the board, they aren't much sought after. As I already have two tractors with these units, IF you are interested in selling, I could put yours on my shelf for parts? E-mail if so. Good luck!
jim

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Howard Trans Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]