Tractor Talk Discussion Board |
Re: tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Restorer on January 05, 2004 at 01:12:37 from (165.247.215.18):
In Reply to: tractors posted by sam on January 03, 2004 at 17:32:06:
Sam: I would suggest that you find a Farmall H that runs and negotiate the price with the owner. First of course you will have to sell the ones that you already have. You can part them out or perhaps sell them as a package to a salvage yard. I have restored two Farmall H's and am now working on a Farmall M. All three were rust buckets and needed a lot of work. The biggest problem that you will have with older tractors is that the engines are usually frozen from rust. The old tractors had cast iron sleeves and pistons. A little moisture and you have rust. If a tractor has been sitting outside for any time at all with the exhaust covered or not, chances are that the engine is frozen and the rings are also frozen in the piston ring grooves. Make sure that the engine will turn over before you buy it. Rebuilding an engine can be very expensive. Stay away from diesels because they can be even more expensive to repair. The reason that I suggest a Farmall H is that International Harvester built so many of them that you can find them fairly easily and parts both used and after market are readily available. Another reason is that the Farmall H is big enough to do most things around a farm and yet not too big to handle small jobs also. I would be glad to share any information or knowledge that I have collected from the Farmall's that I have restored with you. I know where a lot of suppliers of parts, new or used are located. You are welcome to E'mail me or call me at 925-371-1727. Farmall Restorer
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|