Tractor Talk Discussion Board |
Farmall H siezed Engine 1 cyclinder full of water
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Linderman on February 27, 2004 at 14:17:31 from (24.174.91.217):
Thanks everyone, This is a follow up and thank you to eveyone for their advice. After 1 week of the cylinders soaking in oil I filled them with vinegar. I dind't have any turpentine or I would of tried that first. I let her sit for 2 days and tried turning her over no luck. I dropped the oil pan and with a Brick and a scissor jack I jacked up on the #4 Rod Journal and she freed up covering me in vinegar from the cylinders. I let her turn over for a couple minuts using the starter and will put her back together tomorrow and see if she fires and hoping there isn't much if any damage. any advice prior to attempting to start would be apprecited. Again Thanks for all the information. I'll post Final results tomorrow.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|