|
Tractor Talk Discussion Board |
Re: Re: Re: 8N loose steering
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on April 08, 2004 at 10:32:07 from (66.15.112.136):
In Reply to: Re: Re: 8N loose steering posted by Doug on April 06, 2004 at 18:36:11:
Doug - you have to envision what the inside of the early 8N steering box looks like, then it makes perfect sense. The steering rod from the steering wheel comes down inside the steering box towards the front of the box. Then, your left side steering sector is snugged up against the steering rod gear. Then, your right side steering sector is snugged up against the left side steering sector, so that when the left sector turns, it makes the right side turn the opposite direction (this way one arm moves forward, and the other moves back - thus making the wheels turn in the same direction). You want to snug the steering sectors up, so you want them to be pushed TOWARDS the steering rod gear, or the front of the tractor. And, you want the left one tightened up FIRST, if you don't, you will move the right sector forward and snug it up against the left sector, only to then move the left forwards and AWAY from the right (remember, the left side is in the middle)- which you just snugged up. So, move the left sector first, and to move it towards the front of the tractor, you have to turn it counter clockwise (towards the front). Then you move around to the right side and move it forward, which will be clockwise. Hope this helps. Good luck,
Dan
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
