Tractor Talk Discussion Board |
Re: Re: Re: Summer starting question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron on June 28, 2004 at 06:53:06 from (69.179.4.15):
In Reply to: Re: Re: Summer starting question posted by Paul (ONT) on June 28, 2004 at 05:52:44:
Paul, I think you might have found the problem. Absent a service manual, my best understanding is that fuel should be at the injector pump at all times. The bubble above the fuel level in the filter is not the problem but the electric fuel pump might be. That couple of seconds it takes fuel to reach the injector pump tells me that air is being pumped into the injector pump during that time. The service manual would also have a spec for the proper fuel pressure. I have no idea what that might be but if you have an automotive type electric pump they are usually set at 4-7 psi. Another thought... is the fuel return line in place? Low side won't bleed without it. I'm not a big fan of replacing mechanical pumps with electric ones on diesel engines. If it were me, I'd replace the OEM mechanical pump and using the service manual make sure all the lines were in place and then bleed both sides per the manual and then at least I'd have a know good starting point to work from should the problem continue.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|