Tractor Talk Discussion Board |
Re: Tips needed on buying older tractor for brush
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Indydirtfarmer on September 21, 2004 at 12:26:13 from (204.255.236.88):
In Reply to: Re: Tips needed on buying older tractor for brush posted by John (MO) on September 21, 2004 at 11:36:02:
The long and short of it is, when you're done adding all your aftermarket parts, and scavenged repair parts to that D-19. you still have a slow awkward old tractor that isn't very reliable, doesn't have ANY modern operator conveniences, and is a gas hog. The 4020 was (and still is for that matter) a very efficient, easy to operate, very reliable, modern tractor...40 years after it's introduction. No one else had ANYTHING as good as Deere's soundguard cab that came with the next generation of Deere tractors. The D-19 was intended for the average sized farm of the late 50's/ early 60's. (A couple hundred acres...tops) The 4020 was the steppingstone to BIG farms. I know a farmer that worked over 600 acres with ONE 4020, back in 1965. You can "get by" with some tractors, but I want better than "get by". Deere produced THOUSANDS of 4020's every year, for 8 years (Not to mention the 4010) They were the industry standard then. AC, Oliver, Case, IH, Ford, ect. all compared their tractors to the 4020. That tells me the whole story.... They were all trying to play catch up...They didn't make it. About the time Deere was being "Caught", the Next Generation tractors came along. With-in a few years, everyone else was looking for a buyer....for their failing companies. I'm sure you won't relent, but the proof is plain as day. Deere flat ran EVERYONE else out of the country. John
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|