Tractor Talk Discussion Board |
O.T. Sealig around a well casing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene Davis (Ga.) on September 30, 2004 at 18:42:37 from (66.82.9.53):
I need some advice from some of the concrete gurus, and other wise sages and any one else who might know how to do this job. The job to be done is resealing around a 4" steel pipe well casing. There is a 3'x6' x4" slab poured around it and the pump tank house is built on part of the slab. The slab has cracked around the casing, and now I am getting rain water into the well,apparently going down by the gap I see beside the casing. Washing silt into it when we have a heavy rain, the crack is about 1" wide at the worse places. How will it work to mix up some very thin concrete and pour it into the crack? how thin can you mix and pour it and still have it setup? Is it better maybe to take something like the bags of quickcrete and try to pour it into the gap then let it get wet on it's own, then fill the crack in the slab later after that sets up? Will I need to try to pour something like fine gravel and/or sand in the gap beside the casing first to make sure that the dry concrete mix doesn't go too far down? Has anybody ever done this sort of thing. Had to shut the well down when it got really rainy, and use the one at the other house, fortunately we have them connected with pipes and valves to supply both houses when there is a problem with one or the other. Guess I will have to pull the submergible pump up a few feet to get it away from the silt? Need to get this fixed because this leaves me with no reserve for trouble, and if you live in the country and depend on a well for water, it will definitly fail at some time or the other, usually at a bad or wrong time. Would appreciate any advice if any body is willing to share. Thanks Gene Davis
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|