Tractor Talk Discussion Board |
Re: Another Log Splitter Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jdemaris on October 18, 2004 at 18:27:44 from (209.23.28.7):
In Reply to: Another Log Splitter Question posted by WiCraig on October 18, 2004 at 15:27:42:
I don't have a Danauser, but I do have a three point splitter and have also worked on quite a few. There are some pretty good ones around in the $500 price range (new). Biggest complaint I've experienced with them is the tractor's hydraulics being too slow to run them adequately. I bought one a while back from an old guy that was running his off his Ferguson 30. He paid $600 new for the splitter with the 4" diameter cylinder (that puts it in the med. - heavy duty range). It ran too slow, so he then had to buy a PTO hydraulic pump and hydraulic reservoir kit for the splitter and it THEN worked fine. That's the way I bought it. The PTO pump and reservoir cost him an extra $500. I bought the whole works for $400. If I was going to spend over a $1000, I'd just go to Tractor Suppy Co. and buy their largest splitter, self powered with a 12 horse engine, for $1400. One other complaint I've gotten is from using large tractors to run the splitters. Some of the big tractors are not very fuel-efficient running three-point splitters of the tractor's hydraulics. But, everything has plusses an minuses. It's nice not having an extra engine to keep running, but it's kind of pain hooking the splitter up and taking it off (and finding a place to stand it up) if it's a vertical. Make sure the splitter's control valve matches the tractor you are going to use it on (closed center or open center).
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|