Tractor Talk Discussion Board |
Re: 3 angle valve grinding??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on November 12, 2004 at 14:27:44 from (148.78.243.26):
In Reply to: 3 angle valve grinding?? posted by Lynn Kasdorf on November 12, 2004 at 13:03:22:
Hi Lynn, I guess I'm gonna end up being the odd man out and the bad guy on this one. 3-angle seat grinding has been around since forever; it is not a "new thing"; ask any machinist in any town, in any shop. By grinding the seat at different angles, the sealing contact point can be moved either up or down along the valve face seating surface. If the contact point is too either too high or too low on the valve, the valve will burn. This is because with combustion temperatures at about 1200 to 1500 degrees, things are hot in that chamber and the valve has to be cooled by it’s being in perfect contact with the head and in a way as to transfer as much of that heat as possible. Believe me when I tell you that anything less that triple grinding of a valve seat is nothing more than absolute, pure and unabashed "shade tree mechanics". Same old story: there is a right way and there is a wrong way. Once again, just my view and stated as such. Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Plow and Disc - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|