Tractor Talk Discussion Board |
Re: 3 angle valve grinding??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lil-Farmer on November 12, 2004 at 14:49:53 from (205.246.142.55):
In Reply to: Re: 3 angle valve grinding?? posted by Allan in NE on November 12, 2004 at 14:27:44:
I agree 100% with Allen. If I took a set of heads to a shop to have the valves ground and they weren't at least three angle with the seat contact area being 1/16 th to 3/32 nds wide, I wouldn't pay for the job. I have been grinding three angle seats for 50 years, ain't new technolgy. Doesn't require anything but a stone that is more angle than the seat and one that is less angle than the seat. I. E. A 45 degree seat would require a 60 degree stone for the outside and a 30 degree stone for the inside. Use a tube of lipstick (don't tell the wife) and make marks across the face of the valve and use your suction cup to spin the valve in the seat to determine where the contact patch is; move it up and down and control the width by grinding outside or inside. Once it is where you want and the width you want, use some lapping compound to finish the job. Your valve job will last for yearas and years if done properly.
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Plow and Disc - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|