Tractor Talk Discussion Board |
Re: Finished the Boom, Forks and Hitch Pictures
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DH in Carolina on November 18, 2004 at 16:11:41 from (207.144.244.16):
In Reply to: Finished the Boom, Forks and Hitch Pictures posted by Willy-N on November 18, 2004 at 15:02:13:
Hello Willy-N The boom looks good but. If you try to use it like a wrecker to pick up something and try towing it around a curve the boom may collapse over sideways. You may want to add a couple of braces to stop this. Also you may want to add a brace between the boom and upper arm to make it stronger. I have seen a lot of boom poles bent because people try to lift more than they were designed for. Also you should not exceed the rated lift capacity of your tractor lift arms or something may break inside. My .02 Danny Hearl
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|