Tractor Talk Discussion Board |
Re: Finished the Boom, Forks and Hitch Pictures
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Willy-N on November 18, 2004 at 18:01:53 from (64.146.187.188):
In Reply to: Re: Finished the Boom, Forks and Hitch Pictures posted by DH in Carolina on November 18, 2004 at 16:11:41:
I was debating a removable brace from side to side movement for it. Problem is the lift arms are not rigid to start off with. What would be better is a set of adjustible chains from the boom tip to the tractor rear lower link mounts then it could be rigid for moving things around swinging. Also a load that could swing should be ancored to stop the movement. It would be easy to do this just run 2 chain forming a "A" down to the Link mounts off the tip on the boom. There is enought room for this to be done and still room for a hooking point. As far as over lifting most Booms are rated for a load. The ones tractor places sell are rated at 500-1000 lbs max and I have lifted over 3,000 lbs with this one in a test with no problems. The manufactured tube ones I have seen and used would fold even with the braces on them if you over loaded it. I was rating this at 1,000 lbs Max with a 3+ to 1 Saftey factor. I don't feel the added brace between the top support (under Tention) and the boom (under compression) would do that much. Most booms that use that support the weight in a bending moment on the boom and need to beef the boom. This is more of a A-Frame Style support with out the A in the frame. Booms should not be used for lifting heavy stuff if the tractor is on a angle sideways due to making it easier to turn it over on it side. Mark H.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|