Tractor Talk Discussion Board |
Re: Water Well question????????????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on December 11, 2004 at 19:04:59 from (142.177.93.90):
In Reply to: Water Well question???????????? posted by SJ on December 10, 2004 at 18:17:07:
300 feet is not such a long distance. What do you define as a creek? A ditch that carries some water year round or a real river? I wouldn't think a ditch or small brook would be too hard to cross. Just don't forget the applicable permits. In my area, bore holes run in the 150-300 foot range, so they arent cheap to drill. If you have ample flow at the house, a buried line to the barn would be the cheapest way out. Then just put a frost free hydrant in the barn, and there is nothing to worry about. If you do drill a new well, I would just put the bladder tank in the barn. Insulate a box around the tank with 2" styrofoam to keep the drafts out, put a heat lamp on or just a hundred watt bulb, and then put heat cable on all other exposed lines and you should be fine. I have no experience with below ground tanks etc. so can't help there. Perhaps the best advice is to talk to the well driller, as they would be familiar with your local conditions, and could give the best advice. Take care. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|