Tractor Talk Discussion Board |
Re: OT-School Board-Political Help
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Don on February 17, 2005 at 10:14:51 from (209.236.225.203):
In Reply to: OT-School Board-Political Help posted by Dug on February 16, 2005 at 18:02:52:
Dug, I can only tell you of experience from my area and hope it helps you. It seems signs are only to provide name regonition nothing much more (my opinion). The local newspaper here runs an add which lists each candidate with a picture and describes background information. After the background information it lists a statement on candidate issues. Also, you must get your message out to the people and many have made good suggestions, like civics groups, etc..... Getting on talk radio and getting support from talk radio helps a lot. A positive and energetic speach/answers help. I have learned, people dont like to be bother in their private personal time. Anyway, My suggestion would be to remain positive. Rather than describing "going to war" I would make a statement similar to, " I support responsible government that ensures allocated funds are delivered to the proper areas for their intended purposes". I know this is difficult to remain clean and positive with reporters wanting a fight (to get "the story") and loads of negative people enjoying a fight, but the majority of folks(my opinion again) are getting tired of mud slinging and want someone whom produces what they say. Remember, what you say gets you elected (like someone said below) and mean what you say and know you can do it. If you cant, your opponant will roast you later. They will try to roast you anyway, but deliver and then you can say, "see we can do it". Remember to try to stay positive with the negative subjects. Good Luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|