Tractor Talk Discussion Board |
Re: OEM diesel pistons sleeves versus aftermarke
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by fixerupper on March 19, 2005 at 19:04:00 from (206.72.52.5):
In Reply to: Re: OEM diesel pistons sleeves versus aftermarke posted by Mike M on March 19, 2005 at 05:41:36:
A former neighbor of mine had a 190XT Allis that was cranking too slow to start so he would throw the battery charger on it, unscrew the pipe plug in the intake manifold and spray ether in for a godawful long time. When he hit the starter it would kick back a few times and then start with a deafening knock that continued until the ether was cleared out. I ended up overhauling it for him not too long after that and the pistons appeared to be OK but the rods were bent. It was then that I discovered it was cranking slow because the battery terminals were corroded.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|