Tractor Talk Discussion Board |
Re: Gooseneck Trailers
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on August 30, 2005 at 08:12:45 from (4.240.39.155):
In Reply to: Gooseneck Trailers posted by billcrews on August 30, 2005 at 05:27:46:

Hi Bill, In June 05 I bought a Legend 27+5, 10k Dexter dual oil bath tandum duals, Cooper tires, 19# 12" I-beam, 3"channel on 16" centers, 6" channel side rails, 2-1/2"x 3/8" rub rail, 4x2 stake pockets, 2spring assist 20" ramps, rubber mounted lites (all of them), side turn signals, 10" GN frame, Bulldog landing gear and hitch, 6" torque tube, $6400 out the door. I hauled back two tractors about the same weight and size your wanting to haul plus a loose cab and had extra room for another tractor but not the weight capicity. Remember that's really a 40ft long trailer. If I was only going to haul two tractors and that's it, then a 20+5 would be more than enough room. The 6"torque tube is supposed to keep the frame from flexing at the front corners or bending the deck. I'll reserve my thoughts on that after a proven time period. The mfg stated the guys loading round hay bales state the trailer deck doesn't distort after time. If your ever thinking about using the entire flatbed then get the 3rd loading ramp as then the 5ft dovetail is flat. You can't build the 3rd ramp as cheap as the mfg. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|