Tractor Talk Discussion Board |
OT: need advice from machinists
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Midwest redneck on September 10, 2005 at 15:50:54 from (64.136.26.225):
As some of you guys remember my company is going to close in about 5 months. I have been looking for another job and will likely get an offer from the company buying us. The job market stinks. I still have this feeling that I need to start my own machine shop in addition to getting a new job. My garage is all set up for buying a vertical mill, a lathe and surface grinder and cutoff saw. My questions for you guys: I believe that my hourly rate should be 35/hour minimum and then charge more for more difficult work. Does this sound right? It does to me. I would like to borrow $10k from my parents, dont know how that would go over, I have never borrowed money from them before. One of the main reasons for me starting my own shop is because I would control my own destiny instead of a mega-large company kicking me out to the street like a piece of old furniture when I am 53 years old. or younger like now, I am 36 now. Here is another question, how good are the Clausing Atlas milling machines? How good are the Wilton Milling machines? The Wilton has a single phase 3horse motor on their mill, dont need a phase converter on it. I may be able to get a good old lathe from an old friend for a good price. I believe that I will need $35k for all the stuff I will need to get started. If you have your own machine shop or work in one give me your advice I know that Dave in SC has one at least I remember him saying so. I would mostly make fixture pieces, details, and prototype pieces. No high production stuff because I wont have a CNC machine. And no big molds or complex dies unless I think I can do the work and make money. What do you think?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|