Tractor Talk Discussion Board |
Re: O/T Stock Wells
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tony C. on September 28, 2005 at 09:37:12 from (24.187.72.48):
In Reply to: Re: O/T Stock Wells posted by Allan in NE on September 27, 2005 at 21:01:12:
Tell us a little about the variable speed sumersible. Does it us a VFD controller? What is the HP and how much do you figure the variable speed feature added to the cost? What is the make of the controller? I have an 8" well that is about 35' to water and the well is 70' deep. It has a line-shaft turbine in it and a right angle gearhead powered by a gasoline engine. We only use it a few months in the summer. I have toyed with the idea of removing the turbine and replacing it with a 6" 3-phase electric submersible, maybe 12-15hp, dropped in the same casing with a VFD controller. It is located 1000' from the 3-phase power source.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|