Tractor Talk Discussion Board |
Re: Hey You Wheat Guys!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Leroy on October 31, 2005 at 16:55:14 from (209.143.52.18):
In Reply to: Hey You Wheat Guys! posted by Allan in NE on October 31, 2005 at 09:39:50:
Here in Ohio a lot run wheat straw thru the chopper, I do since we no longer have livestalk to need to bale the straw, even when we did we just took the knives out so it did't chop it, just spread it, then clipped the stubble with a cycle bar mower and raked befor baling, most now if bale just leave in row and you do not find a straw spreader here and as far as pluging if by chance it would happen on my deere's, 60's vintage there is a switch inside the back ov machine over walker and if it gets too full that switch will blow a horn to signle you to slow down or that you are starting to plug and if your Gleaner noesen't have it it is only a small job to install one
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|