|
Tractor Talk Discussion Board |
Re: Ford didn't build a bigger tractor - why not ?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dan on November 30, 2005 at 06:22:20 from (66.15.112.136):
In Reply to: Re: Ford didn't build a bigger tractor - why not ? posted by Bill(Wis) on November 29, 2005 at 17:41:27:
Bill - the N Series tractors had the thin .040" steel sleeves in them from day one when the first 9N rolled off the assembly line in 1939 and all the way through the 2N and early 8N tractors as well. These thin steel sleeves worked just fine and would not destruct in one season as you say - they would last many years. While they did go to a thick .090" cast iron sleeve in 1951 mid production on the 8N tractor, it was not because of a problem with the design of the thin steel sleeves, but because you could bore it out to keep you from HAVING to replace the sleeves every time you did an overhaul (which was much harder for the farmer to do himself). In reality, the 119 ci flathead four the N Series used did not get an increase in power from the thin sleeves as you state, and actually had more power by the time they got the thicker sleeves (even though that was not what caused this increase in power). While they did bore the block bigger to accept the thicker sleeves, the inside diameter of the sleeve did not change nor did the piston size. The jump in compression between the 9N/2N tractors and the 8N was not due to the sleeve changes. HTH,
Dan
Replies:
Home
| Forums
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
