Tractor Talk Discussion Board |
Re: OT Pouring Concrete
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RAB on December 12, 2005 at 14:44:10 from (195.93.21.101):
In Reply to: Re: OT Pouring Concrete posted by Galen on December 12, 2005 at 13:56:56:
Sorry 25%. Spent half a lifetime making and testing (as concrete cubes mainly) and analysing cement in cement industry. 10 Newtons at 24 hours 20 Newtons at 3 days 30 Newtons at 7 days 40 newtons at 28 days Or thereabouts - +- about 5 Newtons at 28 days. For the standard BS testing mix - A floor will possibly only need about 20 Newton concrete dependent on loadings and cross section. Rapid hardening cement will have higher initial strengths, but the ultimate strength will probably be less than Ordinary Portland Cement NO steam curing here for 7 day strength at 24 hours! - just standard curing at 20 degrees Celsius, moulds covered with plastic sheet for 24 hours then cubes under water. STEAM curing and accelerators will make a lot of difference. Beams etc need to be de-moulded for a fast turn around of the mould. Floor pads don"t and there is no steam curing here! And concrete won"t even set below about 5 degrees Celsius without accelerators to get it started. We supplied about 4000 tonnes of Cement to concrete manufacturers each day of the week, every week. that was Ordinary Portland, Rapid Hardening Portland, Sulphate Resisting Portland, White, High alumina, and cement blends with fly ash, blast furnace slag, etc. RAB
Replies:
Home
| Forums
Today's Featured Article -
A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|