Tractor Talk Discussion Board |
Re: No buts! Safety first!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on December 12, 2005 at 21:13:42 from (152.163.101.7):
In Reply to: No buts! Safety first! posted by Specter on December 12, 2005 at 17:01:47:
I used to see so many guys using metal chop saws to cut bundles of metal studs on high rise building jobs, sparks, metal chips flying, not to mention the ear piercing noise, no safety glasses and no ear protection. I even wear the glasses in the woods when cutting trees and brush, constantly getting whacked in the face by chips, thorn trees etc. no excuse not to protect your eyes, on my ironworker crews I used to take a grape and poke a toothpick into it, to demonstrate what will happen, it worked well, and the hot slag, I can honestly say that is the worst, it sometimes burns through, then rolls down somewhere until it reaches it's destination, then it just sits and burns while you look like a raving idiot trying to get it off you, almost comical but not, got to protect the eyes though, very important.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|