Tractor Talk Discussion Board |
Re: Dayco Belt Cross Reference
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on January 10, 2006 at 12:32:41 from (66.244.90.98):
In Reply to: Dayco Belt Cross Reference posted by WSM on January 10, 2006 at 11:18:05:
WSM (same as the old original Clear Channel 50,000 watts Nashville AM 650 Grand Ole Opry Radio Station, correct??) Measure the outside length of that belt n see if its 54.5 inches????? Im thinkin/guessing thats what the 545 stands for. I think the L represents the width (is it like 1/2 or 5/8 etc. wide ???) On Gates brand belts they are like A is 1/2 and B is 5/8 etc wide, but Im unsure on the Dayco. This may get you in the ballpark till you get the correct info, but most auto stores can match that number up for ya or even measure its width n length with one of those belt measuring devices usually hangin near the belts. John T
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|