Tractor Talk Discussion Board |
Re: Large 4 wheel farm wagons
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on March 25, 2006 at 15:12:53 from (142.177.97.237):
In Reply to: Large 4 wheel farm wagons posted by Jonfarmer on March 25, 2006 at 10:24:25:
I've run a train with a 12 ton tandem and a 10 ton running gear hauling silage bales. Probably close to 20 ton. I pull them with a Ford 7710, turned to 100+ hp, and ballasted to about 12600#, with FWA. That has no trouble on the road. I wouldn't run on a steep hill in a field. Roads are no problem though. You just use common sense and gears. I've also hauled that train with a Ford 3930 FWA. 45HP, ballasted to about 8000# with a loader. Hauled probably close to 14000#. That's what I've done. I don't recomend it to anyone else, and I certainly wouldn't allow any hired help to do it with my gear, but I'm quite comftorable hauling those combinations myself, withing limits. However, both those units were loaded to the max that the tractors could hold in poor footing. That's about the only time I ever got a bit worried on a tractor. You need to bear in mind that 20 ton is the maximum allowable weight on those running gears. They generally go with a good deal less. The tires seldom stand up to the maximum loading. As a general rule though, I would think that a 150 Hp tractor would be safe with that wagon fully loaded. You can't give a be all, end all rating for every situation where nothing bad would happen. I would think there are peolpe out there who could take a 400 HP articulated job and have a bad accident with that load. It depends on the operators ability, and a good deal of common sense. For what it's worth.... Rod
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|