Tractor Talk Discussion Board |
Re: Need computer advice!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kelly C on February 08, 2006 at 11:34:20 from (65.165.20.97):
In Reply to: Need computer advice! posted by Jonfarmer on February 08, 2006 at 10:18:05:
Hey Jon. Streaming Video is out for dial up. I have built my own computers for years. Also have gotten ready made from Ebay, Dell and EMachines. The Ebay rig was a wreck. About as stable as a pile of glass tooth picks. The Dell I got for my wife. Demension 2400 w/ flat panel screen. Good machine nothing fancy. Had to reinstall operating system on it. That was a joke. Got it done but you better have the driver disks handy or at least write down what hard ware is in it. You can DL any driver but there are multiple types and takes a wile to get the right one. Best buy so far is the Emachines Model WB052. Got this one at Wal-Mart last fall for my Daughter. Came with a 3000+ AMD procesor, 120 gig Hard Drive, Nividea G Force 4 video, DVD burner, 512 meg ddr Ram, Every kind of media card slots, USB out the wazoo and a 17 inch monitor. For about $570. Cant beat that with a stick. Its faster than my home built that I have $2500 in it. Couple years seperate them though.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|