Tractor Talk Discussion Board |
Re: O.T. Wiring help in SW MO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on March 16, 2006 at 15:49:24 from (66.244.90.98):
In Reply to: O.T. Wiring help in SW MO posted by Play farmer on March 16, 2006 at 15:27:08:
Farmer, In Mobile Home services where they require FOUR wires from the service to the panelboard located inside the Mobile Home, the 4 wires are made up of: Two Hot Phase Conductors (L1 and L2) One Neutral (a grounded conductor) One Equipment Ground (a grounding conductor) Then inside the Panel, the Neutral Buss (for the white branch circuit return conductors) and the Equipment Ground Buss (green safety wire grounds) MUST BE ISOLATED AND NOTTTTTT TIED TOGETHER. If it were a residential service entrance main panelboard like the ones inside the residence (NOT a pole or pad mount service used to feed Mobile Homes) the Neutral Buss and the Equipment Ground Buss WOULD BE BONDED TOGETHER AT THE MAIN PANEL but NOTTTTTTTTT in the 4 wire MH Panel. Thats why panels for Mobile Homes or panels used as sub panels MUST HAVE SEPERABLE NEUTRAL AND GROUND BUSSES. Soooooooooooo, run 4 wires (L1, L2, Neutral, Ground) from the pole to the main panel inside the Mobile Home and attach the L1 and L2 to the Main Circuit Breaker top, the Neutral (white) to the Neutral Buss and the Ground (Green) to the Ground Buss. The metallic panel enclosure would be bonded to the equipment ground buss, often via a svrew that goes from the bus to the metal enclosure. The Neutral is earth grounded via connection to a made ground (a grounding electrode such as a driven ground rod) at the outside service, and from that point on the Neutral and Grounds are no longer bonded, thats why you need 4 not 3 wires from the service to the Mobile Home versus only 3 on residential services. John T Nordhoff in Indiana, retired Electrical Engineer)
Replies:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|