Tractor Talk Discussion Board |
OT---ONE BIG LOAD- Talk about heavy haulers
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob-Wyo on April 09, 2006 at 19:10:42 from (69.146.194.81):
Not tractor related to say, but the truck pulling it would out pull a lot of tractors. A refinery vessel was built in Casper, Wyo and transported to the Cheyenne refinery last week. It's weight was 372 TON, 20 feet wide and 205 feet long. Traveled on all 2 lane highways only when school bus's were not running. What a running gear it had, over 100 wheels, and to make a corner each set of dollies had to be turned by hydraulic's as they worked it around the corner and then get it running straigh again, quite a operation for sure. Came right by our house so got a first hand look and of course couldn't find the ---- camera in time. They trucked in a crane that is supposed to be the largest crane in the US just to unload and set the vessel, had to have another crane just to pick up the 3 inch chokers to put them on the big guys hook. Thought it might be interesting to some, just sorry I can't post a pic. Bob
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|