Tractor Talk Discussion Board |
Re: Will it work or just make a mess
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobReeves on April 15, 2006 at 15:28:07 from (70.184.21.215):
In Reply to: Will it work or just make a mess posted by John No Mi on April 15, 2006 at 13:58:03:
Had a flat on the right rear of my Ford 3000 right after I bought it. After the tire was removed we discovered the reason for the flat wass rust from the rim tearing holes in the tube. Bought a new tube, cleaned up the inside of the rim with a wire brush in an angle grinder and ground off some of the real rough spots with another angle grinder. Sprayed the rim with some rust stop I bought at the local auto parts store and after it cured put a good coat of Rustolium over the rust stop. Rim still had pits but everything was smooth. Haven"t had any more problems..
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|