Tractor Talk Discussion Board |
Re: Pulling stumps
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike_Joel on May 25, 2006 at 06:00:49 from (216.227.75.138):
In Reply to: Re: Pulling stumps posted by Billy NY on May 24, 2006 at 20:07:28:
Thanks for the help. Yep. Most people think that a chainsaw will cut them. They dont realized a chainsaw doesnt cut, it rips and grinds, so when it hits flesh (running) it isnt a clean cut it is more like ground beef. One reason people can die so quick from even a small cut. But then a study shows the hammer to be the tool that causes the most injuries every year, but that is simply cause so many peole use them. Again thanks, Mike
Replies:
Home
| Forums
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|