Tractor Talk Discussion Board |
Planting Bermuda grass
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BKahler on June 30, 2006 at 07:17:20 from (207.119.73.8):
Looking for suggestions on how to plant some bermuda grass. We're going to be planting roughly an acre. The ground has been destumped, limed and fertilized. The final prep before planting will be running the box blade over it to loosen it up some. From what I've read bermuda grass should be planted something like 1/2 inch into the ground. After spreading the bermuda would running the box blade over the ground again be sufficient? The only implement I have to work with is the box plade. Also, the spreader is a 36 inch wide unit. I'm not real sure how to set it up for spreading bermuda. I assume I want to make the openings as small as possible. Any info would be greatly appreciated! Brad
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|