Re: Drill a roll pin

Posted by Blue Buddy on July 20, 2006 at 14:13:09 from (216.46.141.14):

In Reply to: Drill a roll pin posted by Don c on July 20, 2006 at 11:19:29:

Harder than heck to drill, couple thoughts, are 2 kinds of pins called "Roll Pins", one is a spiral pin with several rounds of material in it, the other has just one round and a split to the centre down one side, spiral is harder to break if you can find em, but neither will drill well with the overlap and splits in them
Can you slide a small punch or piece of wire down the hollow center, then rotate the shaft to line it up and drive it clean through? if not I would try the welder, tack a bolt or small piece of metal to the end of it and then yank it with a prybar maybe? could do both sides that way, but if you get one side you can likely line stuff up and drive the other parts straight through

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]