Tractor Talk Discussion Board |
IH 574 warning
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by R. John Johnson on August 02, 2006 at 22:41:41 from (205.200.43.249):
In my post below I stated the steering wheel came off the tractor. We owned a 574 in the '70s and had the same thing happen. In both cases the cap on the steering wheel became damaged and was removed. Both tractors sat outside. Water will pool in the center of the steering wheel and there is a path for it to get to the top of the steering motor. A retaining ring holding the input shaft into the motor rusts away, allowing the steering wheel and shaft to come out of the motor. It's been almost 30 years since ours failed, and I haven't seen the neighbor's so my description may be a little off. Anyone out there with an IH utility tractor of this series, if the cap on your steering wheel is gone, check that ring and replace that cap. John
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|