Tractor Talk Discussion Board |
Re: Ford C700 cabover engine?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on August 21, 2006 at 20:23:34 from (142.177.98.126):
In Reply to: Ford C700 cabover engine? posted by OliverGuy on August 21, 2006 at 12:17:42:
If it's a single with a trailing axle, then it's certainly not going to be a performer off road. Stuck and troubled is the phrase...... An air lift wouldn't be so bad. If you got in a jam, you could lift the lift axle, and transfer enough weight to move. The engine wouldn't be such a concern to me as the gearing. For moving some heavy loads, you would want something like a 5 with ruxel or a 5x2 or 5x4. Something with lots of gears, and a good low gear. Good brakes is the other factor. The GVW on the door might not be such a big factor. If it's got the axles, with brakes, you should be OK. I would not be concerned having a gvw of 40000# if the trailing axle has brakes. In an old bomb like that, particulairly one that's been built up locally, the trailing axle could have been added, who knows what engine thrown in, and lord knows what drive line. Those old gas engines were not exactly known for long life spans. Honestly, in my opinion, an old truck like that is worth whatever you think the box and scopes are worth. The truck and it's wetline are a dime a dozen. Around here you can't even sell them for scrap, other than the melting pot. There's plenty of good late model diesel trucks around for not much more money.... especially if you've got to keep it legal..... But, if the box and hoist are good, then it's probably worth the $2000. You can always throw that body on a better truck down the road. Good luck. Rod
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|