Tractor Talk Discussion Board |
Re: fuel guage or sending unit check method
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on September 03, 2006 at 05:45:38 from (66.244.90.5):
In Reply to: fuel guage or sending unit check method posted by daisy on September 02, 2006 at 18:20:35:
Daisy, Typical problemns are either the sender is bad/open or the sender isnt getting a good ground return path or theres no voltage getting to the gauge. Very first is you gotta have hot battery voltage getting to the gauges input (NOT to sender) terminal when the switch is ON. Take a test lamp and place it on the gauge n turn on the switch n see if she lights up??? If not trace backwards for wiring from the switch to the gauge and/or some have a voltage pulser or regulator which supplies either lower or pulsed voltage to the gauge, but regardless theres gotta be power getting to the gauge for it to ever work. Once you have voltage (even if pulsed or reduced) to the gauge, use a jumper to dead ground the gauges output (to tank/sender) terminal and she ought to deflect. If so then the problems NOT the gauge but EITHER the wire from the gauge to sender,,,,,,,,,,,,,or the sender is bad/open,,,,,,,,,,,,,,or the sender isnt getting a good ground. Some have a ground terminal on the gauges top while others may get the ground via the tanks frame. Use a jumper to try n ground the senders frame or if it has its own ground terminal ground it n see what happens.. If the gauge never deflects even with voltage on its input and a dead grounded output I suspect the gauge itself is bad/open. If theres no voltage ever getting to the gauges input you may have a dealer check the parts book to see if it uses a gauge voltage suppy module or some other sort of voltage regulator or pulser etc to power the gauges. Sorry Im not all that familair with newer generation tractors so take this with a grain of salt but it may be a start to isolate if its a bad gauge or a bad sender or sender ground. John T
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|