Tractor Talk Discussion Board |
Re: skidloader engine replacement
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IA Roy on October 16, 2006 at 19:28:49 from (71.7.25.141):
In Reply to: skidloader engine replacement posted by bgoathill on October 16, 2006 at 18:11:41:
Where I used to work in the early 80's they had a skidloader that broke the crankshaft on the Continental engine. This had happened more than once and they decided to do something else. Two guys from the maintenance department went to the Auto Boneyard with a tape measure. They came back with a Ford Pinto 1.6L four cylinder. This cost less than a reground crank for the Continental. It fit right in with some rebuilt motor mounts. The only problem was that it had no governor and was difficult to control. They solved that problem by getting a belt drive governor like they used to put on combines and swathers. Then it worked like a dream.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|