Tractor Talk Discussion Board |
Re: D361 engine ?s (tractor vet please)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on October 29, 2006 at 16:43:23 from (75.19.124.76):
In Reply to: Re: D361 engine ?s (tractor vet please) posted by Brad in WI on October 29, 2006 at 14:46:36:
Well when a D361 is done wright and everything is as it should be then they will start down below 0 with out either and if y never give her a sniff then it will always start . Now if ya have a pump off a 407 then this may be the cause of the wet stacking and also the excess of fuel . Now since i did not see this pump on the test stand and check for myself on the fuel delivery of this pump here again i can not give a good answer . You have to forgive me as i have seen some good pump work and lots of BAD work . One time i had to take a pump to a place that i had never used before and got a call from them telling me that the head was junk , HUMMMmmmmm lets see here tractor started just fine on cold days and ran well just leaked fuel ran up on RPM's just fine but was starting to get COFFEE grounds in the winder well the job was only SUPPOSE to cost 425 bucks now they want 1200 . I tell them that is this pump on the stand at this time he tells me yes and i tell him that I'll be up in just a bit so i run up to this place and tell him that i want to see what this pump is doing on the stand when he start to back pedal and does not want me to have a look well we get into a littel bit of a battel and i flat told him that he was going to show me what this pump was doing or we were going to have a HUGE PROBLEM and he would not like the end results well we go back into the pump room and he fire up the stand and tryes toFLIM FLAM me with running the stand BELOW the rated cranking RPM of the pump at engine cranking speed and this will give ya a low pressure reading and when i told him to turn the speed up to correct cranking speed that the starter turns the engine at start up OH LOW AND BEHOLD the pressure come up to 50 lbs over the low ratting well now that i caught him in a lie then he trys the well the high end is low well yea if ya run it a 1500 rpm less then the rated RPM of the engine so here we go again . I looked at him and said does the pump leak fuel _ no i fixed that but you , no is the govener fixed well yes i fixed that but you need a - No the pump is fine and i will pay ya what you told me it was going to cost and i am out of here with that pump . Before i sent anything out to people that i did not know i would always stamp a letter and a couple # on the pice just to make sure that i got back what i sent in and also put a match line to make sure that i did not get back a sherman and williams over haul. Well that was 10 years ago and that old junk pump is still on that 1950 OIL ALL OVER and i was on it for 5 days this fall packen silage and guess what it still runs just fine . So here i think that the 407 pump is set a bit to rich for a 361 and how it would act set back well i would have to see it on a stand .
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|