Tractor Talk Discussion Board |
Re: I think I need an IHC Hydro. Maybe 84.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave from MN on October 31, 2006 at 05:32:15 from (67.133.91.28):
In Reply to: I think I need an IHC Hydro. Maybe 84. posted by Stetts on October 30, 2006 at 22:47:08:
I have a 544D Hydro. Hydro drives are very nice to have for most any PTO work. For tillage I would recommend having or borrowing a gear drive. I have noticed that my hydro dont seem to have the raw power of the same model in a gear drive. I have heard that the hydro pump takes about 20HP from the tractor pulling power, dont know if its true or not. Everyone told me to stay away from the hydro's. I tried her out before buying to see if the hydro slipped or had any other loud issues when being used. You should be able to stall the engine locking the brakes or putting a hard load on the tractor at a low to med idle, just as you would a gear drive. There are days I wish I had a gear drive, but there is never a day that I wish I did not have this Hydro. You will use quite a bit more fuel with the Hydro than a gear drive so make sure that is in you plans. Other wise happy shopping
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|